Keep and Share logo     Log In  |  Mobile View  |  Help  
 
Visiting
 
Select a Color
   
 
SOME INTERESTING DRAGSTER FACTS
 
Hi - I received this interesting email and thought I would share it with you. I am not sure who the author is.
 
--------------------------
 
'DEFINITION OF ACCELERATION '   4 Strokes Rule
 
One top fuel dragster 500 cubic inch Hemi engine makes more horsepower
than the first 4 rows of stock cars at the Daytona 500.
 
It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA 
Top Fuel dragster eng ine to reach the rear wheels. 
  
Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro 
methane per second; a fully loaded 747 consumes jet fuel at the same rate 
with 25% less energy being produced. 
  
A stock Dodge Hemi V8 engine cannot produce enough power to drive the 
dragster's supercharger.
 
With 3,000 CFM of air being rammed in by the supercharger on overdrive, 
the fuel mixture is compressed into a near-solid form before ignition. 
  
Cylinders run on the verge of hydraulic lock at full throttle.
 
At the stoichiometric (stoichiometry: methodology and technology by 
which quantities of reactants and products in chemical reactions are 
determined) 1.7:1 air/fuel mixture of nitro methane, the flame front 
temperature measures 7,050 deg F.
 
Nitro methane burns yellow.. The spectacular white flame seen above the 
stacks at night is raw burning hydrogen, dissociated from atmospheric water 
vapor by the searing exhaust gases.
 
Dual magnetos supply 44 amps to each spark plug.  This is the output of 
an arc welder in each cylinder.
 
Spark plug electrodes are totally consumed during a pass. After 
halfway, the engine is dieseling from compression, plus the glow of exhaust 
valves at 1,400 deg F. The engine can only be shut down by cutting the fuel 
flow.
 
If spark momentarily fails early in the run, unburned nitro builds up in 
the affected cylinders and then explodes with sufficient force to blow 
cylinder heads off the block in pieces or split the block in half. 
  
In order to exceed 300 mph in 4. 5 seconds, dragsters must accelerate an
average of over 4G's. In order to reach 200 mph (well before half-track), 
the launch acceleration approaches 8G's.
 
Dragsters reach over 300 miles per hour before you have completed 
reading this sentence.
 
Top fuel engines turn approximately 540 revolutions from light to light! 
Including the burnout, the engine must only survive 900 revolutions under 
load.
 
The redline is actually quite high at 9,500 rpm.
 
Assuming all the equipment is paid off, the crew worked for free, and 
for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second. 
  
The current top fuel dragster elapsed time record is 4.428 seconds for
the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ).
The top speed record is 336.15 mph as measured over the last 66' of
the run (05/25/05 Tony Schumacher, at Hebron , OH ).
 
Putting all of this into perspective:
 
You are driving the average $140,000 Lingenfelter 'twin-turbo' powered 
Corvette Z06.  Over a mile up the road, a top fuel dragster is staged and 
ready to launch down a quarter mile strip as you pass. You have the 
advantage of a flying start. You run the 'Vette hard up through the gears
and blast across the starting line and pass the dragster at an honest 200
mph. The 'tree' goes green for both of you at that moment.
 
The dragster launches and starts after you. You keep your foot down 
hard, but you hear an incredibly brutal whine that sears your eardrums and 
within 3 seconds, the dragster catches and passes you. He beats you to the 
finish line, a quarter mile away from where you just passed him. 
  
Think about it, from a standing start, the dragster had spotted you 200 
mph and not only caught, but nearly blasted you off the road when he passed
you within a mere 1,320 foot long race course. 
  
... and that my friend, is ACCELERATION !
 

Creation date: Jan 12, 2010 12:05pm     Last modified date: Jan 12, 2010 12:31pm   Last visit date: Dec 6, 2024 11:08pm
    Report Objectionable Content