Which is good for the bus processing (how to choose the copper processing machine of the Shaanxi mother)

The topic I want to share with you today is that the busbar machine includes the following explanations. You can have more understanding of this aspect!

Let's talk about the first type of wiring. The wires used by the winding coil generally mainly include the following lacquer wrap, paper bag, and membrane bag. Due to the different use and pressure resistance requirements of different types of coils, they are generally based on their own themselves. Select different wires.

Which of the bus processing includes which one is better to remove the front and rear material board, and then push the card iron to about 1-2mm in the I negative, take 1 E-piece to put it vertically on the card iron, use 0.3mm thickness to thickly use 0.3mm thick

When the hot oil is clean, the temperature of the oil should not exceed 20 ° C. If you use the light fire directly, you should pay attention to avoid burning the oil. The bearings should be hung in the oil pan.

China's transformer industry is fiercely competitive, foreign -funded multinational companies have seized a large market share, and the number of domestic transformer manufacturing companies is also rapid. There are more than 20 enterprises with 220kV transformer production capacity in the low -end transformer market, and more than 100 companies with 110kV transformer product production capacity. The production of transformer enterprises above 500kV levels has built high barriers to enter through technology and capacity, and the market structure tends to stabilize.

The line line uses a linear motor technology to replace the current roller screw technology commonly used in the current parent line rowing. While improving the accuracy of the lines, it improves the acceleration. In addition to continuously adopting new functional components on the transformer's bus, the beating of the necessary work molds and concentrics of high -speed winding molds. Under the high -speed movement controlled by the system, professional and reasonable design requires high -precision processing to meet high -quality coils. Demand by winding. Which one is better for home processing

Morning inspections: Weekly protection and maintenance should be performed after every 40 operations. If the environment is poor, the cycle should be shortened. Note: The lubricant and lubricant must be good quality. Otherwise, the surface friction of the screw or rail will be increased, thereby shortening the life of the screw and the accurate positioning of the machine. Warning: Do not use phosphate and oxide synthesizers in lubricating devices or factories. Check the equipment in the lubrication device. If necessary, you can add 100CKR lubricating oil.

Which good bending machine including the bus is the same as the shear machine, it has a long history of industrial history. As early as the late Qing Dynasty, Germany had entered the industrial era. The earliest shear machines and bending machines were originally from the European continent. The earliest development of two machine tools was Germany.

The supporting parts are components used to install power skaters, cut heads or fixtures with feed mechanisms, and other components.