The golfer must correct any marks left by the balls when they hit the green. They can be repaired by golfers using the golf divot instrument. However, if used incorrectly the divot repair tool could cause additional damage to the green. USGA golf etiquette rules require that players be sure to repair any divots made by their ball or cleats onto the green after the conclusion of the hole. Players should also attempt to repair additional ball marks on the green in order to maintain the condition of the golf course.

Step 1

Push down and then move to the left using the tool for repair in order to push the turf of the putting area in a direction toward the middle of the hole. Be careful not to press too hard on the ground at the lower part of the ball mark or damage to the putting area could be caused.

Step 2

Move the ball repair tool towards the side to close the mark of the ball. Repeat this process until the area is completely covered in turf. Push the sides or divots together.

Step 3.

Make a mark on the affected part of the green with putter to complete the repair. Make sure to tap the green lightly, as soft greens could be further damaged when you apply too much force.

How to use a Golf Divot Tool

Each golfer is accountable for the care and maintenance of the course. It is common that a shot will hit the green, leaving an impression.

If it is fixed correctly, a ball mark can heal within 24 hours. Untreated ball marks can last up to a week to heal.

Step 1

Find the ball's marks on green. Sometimes it can be difficult to locate ball marks on the green. Instead, focus on exactly where your ball landed.

Step 2

Then push the custom ball markers golf slightly in toward the front. This pushes the ball mark towards the center. Do not try to pull the grass back using the repair toll for divots always push it down and forward.

Step 3.

Restore all the sides of the ball mark in order to completely repair the mark. When the grass is done, it should completely over the mark.

Step 4

Use your putter to lightly tap on the ball mark. Tapping down on the ball mark helps to level out the repair.

Step 5

If you're in the mood, add one more ball mark. Always aim to leave the golf course in better condition than you were when you arrived.

How do I Clean Golf Balls at Home?

Dirt and debris can affect the speed and flight of a well-hit golf ball. Dimples in golf balls convert spin from drives into lift.

But mud and other debris within the dimples could affect the ball's performance.

Purchasing new golf balls can be an option, but it can be costly and unnecessary. Follow these easy steps to make your golf balls shine again after being covered in dirt and other debris.

Step 1

Put a bucket or container that is able to hold a gallon of water onto an unflat surface so that water won't cause any damage. Set an old towel or rag underneath the bucket to collect any splashed or dripped water.

Step 2

To fill up the bucket or container make sure you add three-fourths to a gallon hot water. Be careful when pouring hot water. It should not splash. Add three effervescent dental cleaning tablets to the water. To increase the amount of cleaning bubbles in your water you can make use of an extended spoon or other object to place tablets at the container's bottom.

Step 3.

Include the golf balls with dirt into the hot water bucket, along with denture cleaning tablets. Do not wait too long between adding the tablets and golf balls. Allow the golf balls with dirt to sit in the clean bubbles for a few minutes.

Step 4

Pick one golf ball at a go and examine them for dirt or other particles.

To get rid of any remaining debris, you can employ an old toothbrush. To clean loose particles and denture cleaner, wash the golf balls with cool running water.

Step 5

Dry your golf balls using a clean rag. Put the golf balls in an area in which they will continue to air dry prior to they are put back in your golf bag.